Peumatic Grouting pump is designed for stress and filling grouting of cement and bentonite slurries. It is primarily used for injecting (grouting) bar anchors and the drill holes in order to reinforce the free rock mass. The maximum grain measurement can’t exceed 0.2 mm.
Grouting pump operation and upkeep is simple, safe and reliable. This pump is utilized in mines operating under difficult situations because it’s dependable and explosion-proof.
Basic Pneumatic Grouting pump embody: An air inlet, the pneumatic cylinder, mounting base frame and stand, pressure gauge, pumping cylinder, outlet with fast launch coupling and wheels.
How it actually works
Pneumatic stress in the air cylinder exerts a excessive strain on the grout combination which ends up in ejection of grout with a high stress and velocity. The valves of the air cylinder within the pump function mechanically to actuate the cylinder. The pneumatic cylinder then strikes the plunger up and down to finish the pumping cycle.
Pneumatic grout pump could be pushed even without Electrical energy provide in distant areas by utilizing engine driven compressor.
Applications
The pump is majorly used in development and mining industry for injecting material into broad and medium measurement hole in beams, columns ,basement walls and flooring, lift shaft concrete wall fill-up and so forth. In mining industry it is used to fill up cement solution the place there’s a gap exists between construction and rock and for soil stabilization.
Detachable design tends to straightforward upkeep and transportation. Challenging works like Grouting in Bridges.
READ: How hydraulic submersible pumps work
This pump is broadly utilized in tunnels, coal mine, bridges and dams, building foundation, and other underground tasks, and inflammable, explosive websites and different bad surroundings.
It has software in chemical industry also to pump out chemical slurries.
The pump is electrical energy free so, can be used at any web site condition whether or not it is rural or urban.
Mining Pneumatic Grouting pump has a bigger discharge slurry adjustment range. Generally the ultimate amount of the grouting quantity is eight or10 occasions of the quantity at first. And the ultimate grouting quantity proves that filling is compacted.
Simply put; Pneumatic high-pressure grouting pump is specifically designed for high-pressure grouting. And it adopts full hydraulic drive, it’s strain and move can be adjusted according to the necessities of grouting,(The flow of grouting pump is 0-100L/min, pressure of discharge is 0-10MPa).in addition to, This Pneumatic high-pressure grouting pump can be used for grouting single or double fluid.
High-pressure grouting pump is principally used for highways, railways, water and electricity, development, mining and so forth. ground/underground building.
Benefits
Mining Pneumatic Grouting pump has the advantages of low vitality consumption, small vibration, low noise, small dimension, excessive efficiency, dependable efficiency, strain and flow control, lengthy life and so on. Common mine grouting pump has pneumatic injection pump, dual fluid injection pump, extrusion injection pump and piston injection pump.
Pneumatic grout pump can be Light weight and with a wheelie design it may be carried simply. It is designed for straightforward operation and low maintenance. ตัววัดแรงดันน้ำมัน however not least its spare parts are easily available.
Share